I'm into a little dilemma here. I bought a server, running Ubuntu, having 255 IP addresses and now I need to see them. I've searched the internet before posting here and found out that the command "ip address show" would spit up all my IPs, but instead it shows me this :
1: lo: <LOOPBACK,UP,LOWER_UP> mtu 16436 qdisc noqueue state UNKNOWN
link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
inet 127.0.0.1/8 scope host lo
inet6 ::1/128 scope host
valid_lft forever preferred_lft forever
2: eth0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc pfifo_fast state UP qlen 1000
link/ether 00:11:09:3b:3c:62 brd ff:ff:ff:ff:ff:ff
inet x3.xx5.x4.10/27 brd x3.xx5.x4.255 scope global eth0
inet6 fex0::2x1:xff:fxb:3cx2/64 scope link
valid_lft forever preferred_lft forever
Do I really have those IPs ? Is this the right command ? Maybe I don't know how to read.
Later edit for ErikA:
sudo ifconfig shows:
eth0 Link encap:Ethernet HWaddr 00:11:09:3b:3c:62
inet addr:x3.xx5.xx4.10 Bcast:x3.xx5.xx4.255 Mask:255.255.255.224
inet6 addr: xx80::2x1:xff:fx3b:xc62/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:2722000 errors:0 dropped:0 overruns:0 frame:0
TX packets:2673250 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:1477640288 (1.4 GB) TX bytes:319971949 (319.9 MB)
Interrupt:48
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:918033 errors:0 dropped:0 overruns:0 frame:0
TX packets:918033 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:99535482 (99.5 MB) TX bytes:99535482 (99.5 MB)
It's not a hosting company, I get the IPs from the ISP. I just need to know what are my IP addresses, for paying the bill, not to get pwnd at pricing.
Maybe the server is not configured ? Can you please give me some keywords that i should look into over google ? Some guides, infos, anything. I really need to do this configuration.