2

I am using ssh to remotely connect to a Dell PowerConnect switch (Dell uses the same commands as Cisco). I need to change the ip address of vlan 1 from 192.x.x.x to 10.x.x.x. I am able to add the new address of 10.x.x.x by:

console(config-if)# ip address 10.x.x.x 255.x.x.x

Now vlan 1 will reply from both 10.x.x.x and 192.x.x.x . How do I then remove the existing 192.x.x.x from that interface?

1
  • Dell and Cisco switches have similar commands, but they diverge quite a lot once you start configuring spanning-tree and I am sure some other things too. Would be great if Dell took the trouble of publishing a cheat sheet to translate between the two.
    – dunxd
    Feb 3, 2011 at 14:15

3 Answers 3

8

It's been a while since I've worked on Cisco gear, so this may be incorrect, but give this a try:

> no ip address 192.x.x.x 255.255.255.0
4
  • That looks correct to me and it's only been two days since I last removed an IP address from a Cisco device.
    – Vatine
    Aug 31, 2010 at 15:28
  • So, it appears not all the commands are the same. 'no ip address 192.x.x.x 255.255.255.0' returns "Wrong number of parameters or invalid range, size or characters entered." And 'no ip address 192.x.x.x' removes both ips
    – pizzim13
    Aug 31, 2010 at 16:29
  • 1
    Then try no ip address 192.x.x.x.
    – EEAA
    Aug 31, 2010 at 16:35
  • On Dell PowerConnect switches, When you aren't sure how a command works, try typing it followed by ? which will then show you the possible options. You can keep typing at ? at the end of the command to see further options. If you see <cr> it means you don't have to add any other commands.
    – dunxd
    Feb 3, 2011 at 14:10
1

(config-if)no ip address 192.x.x.x 255.x.x.x

Will remove the IP addresses.

1

In the global config mode run:

int vlan 1

followed by

no ip address

And this should do the job.This wud delete all the ip addresses on the vlan,Then you can give it the ip address u want over again

0

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .