I have a SAN with redundant cisco 2960s when I set it up a while ago I set all of the interfaces to use an MTU of 9000. I was looking at the config today and I noticed this line system mtu routing 1500
will that cause any problems? or because this is a switch everything should be fine because there isn't any routing.
-
I assume this is for iSCSI? Is jumbo frames enabled on the array and the servers?– mrdennyMay 4, 2011 at 19:10
Add a comment
|
1 Answer
Peter, you can rest safe knowing that system mtu routing 1500
only affects routed Vlans.