2

I have Dell PowerEdge 1950 with hardware raid Perc 5/i.

I want use software raid md/lvm.

Is any way to totally disable this raid and see "raw" sata disks?

I play alot with BIOS , enable SATA, disable raid controller, but nothing happents, i not see the disks.

Any advice?

3
  • out of curiosity - can you please tell why do you prefer md/lvm instead of perc in this case? thx!
    – pQd
    Aug 2, 2012 at 6:10
  • I hate this perc. Its slow, and low featured. For example i have 2 disk 500G and 1T and want create 500G raid1 and 500G without raid. With perc - i cant do that. Also Megacli utility - terrible. Also md and lvm works very well. Aug 2, 2012 at 8:03
  • "Its slow" it is not any slower than software raid will be.
    – JamesRyan
    Oct 8, 2014 at 13:02

2 Answers 2

3

I had a similar problem with the LSI controller. I've every single disk exported as a JBOD device.

1
  • Jbod with one disk, look like raid0 on one disk. Thanks. Good idea. Aug 2, 2012 at 12:32
2

Are you trying to use a filesystem solution like ZFS, which prefers RAW disks? If so, the better long-term approach is to use a dedicated SAS controller (HBA) instead of a RAID controller. I tend to prefer LSI's offerings.

Also see: ZFS SAS/SATA controller recommendations

2
  • Thanks alot. Yes, i want something like zfs, but on this hardware, without upgrades. Just wonder if it possible. Aug 2, 2012 at 12:30
  • Nope. Not unless you create RAID 0 arrays comprised of one disk each and present the resulting volumes to ZFS.
    – ewwhite
    Aug 2, 2012 at 12:40

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .