0

I want to be able to push f/w logging traffic to a server at a remote site. This server is accepting syslog traffic on port 514. In the ASA I've configured it to use this server as a syslog server.

The Cisco f/w's inside interface address is 10.0.0.1 and I want to route over the link to an address of 192.168.1.1. The vpn is up and working between sites, and local clients at each site can access resources etc.

How would I go about setting up the route from the f/w to this remote server only?

Improve this question
3
  • 1
    Is the ASA's inside interface in one of the subnets that's being sent over the VPN?
    – Shane Madden
    Nov 19, 2012 at 6:26
  • Yes. The local network on the ASA side is 10.0.0.0 255.255.255.0. ASA IP is 10.0.0.1.
    – Wookie321
    Nov 19, 2012 at 7:19
  • is the host 192.168.1.1 or the subnet the host exists on a part of the vpn encryption domain?
    – user1008764
    Nov 19, 2012 at 20:05

1 Answer 1

Reset to default
1

On the remote site, set the logging host inside <ipnr syslogserver> and make sure to set the management interface on inside.

So this should cover it:

  • management-access inside
  • logging host inside ipnr syslogserver
Improve this answer

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .