2

I have a strange issue with ipv6 on Ubuntu 12.04.

There are two hosts, directly connected to the internet. Both have assigned a /64 network. They are properly configured with a /128 endpoint each and one can ping6 the other and vice versa. My plan was to terminate a /112 subnet of my assigned ipv6/64 to the interface to have plenty of addresses for usage in apache2 vhosts. But that's not the point.

Host A:

$ ifconfig
eth0      Link encap:Ethernet  HWaddr (...)
          inet6 addr: fe80::5246:5dff:(...)/64 Scope:Link
          inet6 addr: 2a01:xxx:xxx:000A::2/64 Scope:Global

$ route -A inet6
Kernel IPv6 routing table
Destination                    Next Hop                   Flag Met Ref Use If
2a01:xxx:xx:000A::/64          ::                         U    256 0     0 eth0
fe80::/64                      ::                         U    256 0     0 eth0
::/0                           fe80::1                    UG   1024 0     0 eth0
::/0                           ::                         !n   -1  1  5689 lo
::1/128                        ::                         Un   0   1    18 lo
2a01:xxx:xx:000A::2/128        ::                         Un   0   1   202 lo
2a01:xxx:xx:000A::/112        ::                         U    1024 0     0 lo
fe80::5246:5dff:fea1:977c/128  ::                         Un   0   1    86 lo
ff00::/8                       ::                         U    256 0     0 eth0
::/0                           ::                         !n   -1  1  5689 lo

Host B can ping6 2a01:xxx:xx:000A::[0001-FFFF] correctly and works as I expected it. But on Host A, I cannot ping my own Addresses. If I try to ping6 2a01:xxx:xxx:000A::n, I get this one:

$ ping6 2a01:xxx:xxx:000A::3
PING (...) 56 data bytes
ping: sendmsg: Invalid argument
ping: sendmsg: Invalid argument
ping: sendmsg: Invalid argument

I suspect the routing table, but I've played around with it a long time and even using google I can't get it work.

Any Ideas? Thanks.

1 Answer 1

3

You have configured 2a01:xxx:xx:000a::/112 on lo. The most specific prefix wins* so you're trying to ping an IP address (::3) on your lo interface that isn't there. You should just configure all the addresses you need on eth0 and remove the /112 route and the /128 from lo.

*) How it works: Routing decisions are made by looking up the "most specific" route. That means the route with the longest prefix mask. In your case:

2a01:xxx:xxx:000A::3

This address is contained in the following networks:

::/0                           fe80::1                    UG   1024 0     0 eth0
2a01:xxx:xx:000A::/64          ::                         U    256 0     0 eth0
2a01:xxx:xx:000A::/112        ::                         U    1024 0     0 lo

Most specific is the network with mask /112 so that is where the packet is routed. As this is your lo interface (and you don't have the IP configured there) the ping fails.

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .