All I'm trying to do is copy the running-config from a Cisco Catalyst 2560 PoE 24, to a Catalyst 3560 PoE 48. This is f0/1 from the original switch:
interface FastEthernet0/1
switchport access vlan 40
switchport mode access
switchport voice vlan 98
srr-queue bandwidth share 10 10 60 20
priority-queue out
mls qos trust cos
auto qos trust <----------------------
no cdp enable
spanning-tree portfast
On the previous 2560 it was set to "auto qos voip trust" (the arrow); I get the following error when I import the running-config into the 3560:
AutoQoS Error: AutoQoS already configured
I turned off autoqos with a debug auto qos and a no mls qos globally, removed the auto qos trust then a auto qos voip trust
I received no warnings after entering the last command but on a show config, it's still not listing the voip trust. Any ideas where to look?
Thanks!