Take the 2-minute tour ×
Server Fault is a question and answer site for system and network administrators. It's 100% free, no registration required.

I'm looking at buying a hot-swap NAS that supports SATA/SATA II hard drives. Can I get any SATA drive and put it into the hot-swap trays it comes with, or will I need to find a certain kind of drive?

share|improve this question

4 Answers 4

up vote 7 down vote accepted

Normaly any SATA I/II you can found in the markey will fit in. Check you NAS documentation to see if there some limitation about it.

Hope this help.

share|improve this answer

Any on the NAS drive's HCL will do. If you tell us which models you're looking at or have bought we could help you get the best out of it.

share|improve this answer
    
I was looking at the Netgear ReadyNAS 1100 cdw.com/shop/products/default.aspx?EDC=1356393 –  Jeffrey May 20 '09 at 14:30
    
Maybe you could add that to the question at the top. –  Jay R. May 20 '09 at 15:24

Typically, the hotswap drive needs to be essentially identical to the drive it is replacing, but every system is different.

Some systems can support swapping in a bigger drive with similar characteristics, with the excess space being unusable. Certainly, it can't be smaller than the drive it is replacing. I imagine that the tolerance for similar but bigger drives would be discussed in the technical specs of the system, or can be obtained from the company support mechanisms.

One of the very unique features of the Drobo system is that it can handle size and flavor of drives.

share|improve this answer
    
I think Jeffrey's NAS is empty to start with, and he's wondering which drives he can buy. –  nray Sep 26 '09 at 17:03

Your NAS solution may have only been tested with a particular kind of drive, including firmware version. It may have custom firmware.

You will have to trust the manufacturer's advice about supported drives. Even though they may deliberately deceive you so that they exclusively can sell you overpriced drives, there's no way to determine whether this is the case or whether there is a good reason for a particular drive.

Most flaky SATA solutions I've seen have problems due to interactions between drives and the controller. A drive that the controller vendor never tested is asking for more problems.

If it's a very low-end NAS solution, the problems caused by the NAS itself will probably eclipse any problems caused by drive/controller compatibility. And it is unlikely that there is custom firmware, or even serious testing of drives by the vendor.

share|improve this answer

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.