Take the 2-minute tour ×
Server Fault is a question and answer site for professional system and network administrators. It's 100% free, no registration required.

I'm attempting to set up an IPv6 testbed. Very basic: Just two Ubuntu Linux boxes talking to each other over a LAN. Both boxes have working IPv4 connectivity, but I have had no luck using SSH over IPv6. Following this HOWTO, I've given both machines addresses in the site local range (fec0::). On the first box, I ran:

sudo ifconfig eth0 inet6 add fec0::1/64

And on the second, I ran:

sudo ifconfig eth0 inet6 add fec0::2/64

I then checked the routing table, and each appears to have a route to that network going through the eth0 interface. Next, I added an entry in /etc/hosts pointing from the second box to the first. But when I then try to SSH from the second box to the first, the SSH client simply hangs. No error or anything. If I run tcpdump on the client, I see no IPv6 traffic at all. What's going on?

Note that if I SSH to the ip6-localhost address from the server machine to itself, it works fine, so it doesn't seem to be an SSH problem. Any help greatly appreciated.

share|improve this question
    
silly point, but check if ipv6 isn't firewalled –  Tobu Jan 27 '10 at 21:28
    
Also, how are the two boxes networked? Are they connected directly via cross over cable, connected via hub, switch or router? –  Barton Chittenden Feb 14 '11 at 21:38

2 Answers 2

up vote 2 down vote accepted

First, if you have ufw installed, check /etc/default/ufw to see if the IPV6=no option is set. You'll have to set this to yes or ufw will firewall all IPv6 traffic by default.

After doing this, try some basic diagnostics that you should know about as you're learning IPv6.

The first thing you should do is install the ndisc6 package and then try to do a neighbor solicitation. (this is the equivalent of doing an ARP request in IPv4)

sudo apt-get install ndisc6

Note, you'll need the universe repository enabled for this.

Then, from your first machine:

ndisc6 fec0::2 eth0

This will ensure that you can find the MAC address for fec0::2.

(Note, the ndisc6 package also comes with a handy utility called rdisc6 which can be useful if you have an IPv6 router on your network; it will check to see if the router is correctly responding.)

After validating that neighbor discovery works, next try ping6 fec0::2.

Other diagnostics you might want to post if you're still having problems:

/sbin/ip -6 addr
/sbin/ip -6 neigh
/sbin/ip -6 route
sudo /sbin/ip6tables -L
share|improve this answer

We'll need a little more info to really help -- For starters, can you successfully ping between the two hosts over IPv6? If you can't ping you've got a more basic issue to sort out still...

Assuming you can ping (basic connectivity works) double check in netstat (or by SSHing to the fec0::N address from the local box) to make sure your SSH daemon is listening on the IPv6 addresses you're trying to use. You might need to edit your sshd.conf file and/or restart sshd so it realizes there are new v6 addresses to listen on.

share|improve this answer
    
Running "ping6" gives me an "operation not permitted" error even when I run under sudo. I will have to check netstat and get back to you. FWIW, IPv4 connectivity between the boxes works perfectly. –  Rob H Jan 27 '10 at 18:27

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.