0

I'm gradually upgrading a Slackware 12.0 to a 13.0.
Using slapt-get I've done it gradually, just in case. So I've done 12.0 -> 12.1, 12.1 -> 12.2.

I've sorted out that I need to manually upgrade pkgtools and fresh install xz just to get it to install the new package format.

After Googling for the subject I've stumbled upon someone that did a kernel upgrade from 12.1 to 13.0 and he's complaining about /dev/hda being switched to /dev/sda.

Is this correct and I'll have to boot from a 13.0 CD to get LILO working or can I just run LILO after slapt-get finishes the dist-upgrade?

1
  • To both my answer I want to convey that I did a 13.0 upgrade with slapt-get with no hitch and all is well. Hurra for slapt-get!! Nov 14, 2010 at 0:16

2 Answers 2

1

Using slapt-get I've done it gradually, just in case. So I've done 12.0 -> 12.1, 12.1 -> 12.2.

slapt-get is not officially supported, it is a third party tool. If you use it, complain to its developers. Canonical Slackware users do not use third-party tools for upgrading. They use their brain. When a new Slackware version is released, it contains an UPGRADE.TXT file. Those are high-quality instructions for manual upgrade. Follow them and do the upgrade by hand, do not let a third party tool screw up your system.

After Googling for the subject I've stumbled upon someone that did a kernel upgrade from 12.1 to 13.0 and he's complaining about /dev/hda being switched to /dev/sda.

linuxquestions.org is a place for newbies. Do not blindly take their word for everything. Read the official Slackware docs. A Slackware 13.0 default kernel works fine with /dev/hda names. I can vouch for that because I'm running Slackware 13.0 on a computer that has an IDE drive. The transition to /dev/sda* is made only in Slackware-current, which is not Slackware 13.0. Relevant quote from the ChangeLog:

+--------------------------+
Mon Jan  4 21:43:02 UTC 2010
New kernels...  and this deserves a mention/warning:  the last bits of the
"old" IDE/ATA system have been removed now.  Everything should be using
the libata based drivers now, so if you have any drives that are currently
running as /dev/hda, /dev/hdb, etc., when you reboot with these kernels all
drives will be renamed as /dev/sda, /dev/sdb, etc.  If you had any /dev/sd*
already, they might get renamed.  Adjustments may be required in
/etc/lilo.conf, /etc/fstab, the initrd, and elsewhere.  Good luck!

Again, this is not 13.0, this is the bleeding-edge -current, which you wouldn't want to have running on your server anyway. -current is for testing purposes, it's being polished until it becomes stable and usable.

0

I think it's better to make a clean install of any new Slackware. Yes it's possible to upgrade manual but there is a chance you screw up your system bad. For me it's better as I've separated my partitions and my software is located on a different partition from the system's partition.
If you chose to go with manual upgrade read the "UPGRADE.TXT" and follow the directions carefully !!

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .