up vote 0 down vote favorite
share [g+] share [fb]

Cisco has "sdm templates" and the number of mac, arp, ace, route entires depends on template type. Is there something like that in Juniper switches?

link|improve this question
79% accept rate
feedback

1 Answer

up vote 0 down vote

There is no such command, because juniper support features out-of-the-box, without TCAM refragmentation, as in Cisco.

link|improve this answer
I believe you are correct that there is no equivalent, but I am certain JunOS has a ton of tuning options. Check out the the ethernet-switching section of the configuration, looks like there are plenty of per-interface options. I can tell you that unless that EX3200 is a core switch with a few hundred other switches connected you're probably not going to overwhelm it for resources. – SpacemanSpiff Jun 27 '11 at 21:06
feedback

Your Answer

 
or
required, but never shown
discard

Not the answer you're looking for? Browse other questions tagged or ask your own question.