Take the 2-minute tour ×
Server Fault is a question and answer site for professional system and network administrators. It's 100% free, no registration required.

i have 3 servers, all relatively the same hardware/config, etc. I run some data pulls on all 3, and on 2 of them, they have 1 nic, and they work fine. On the other , there are 2 nics, and unless they are both plugged in or teamed, the processes time out.

Any ideas on why this would be? It doesn't make sense to me, as the other two work fine with 1 nic and don't time out when running the same processes.

share|improve this question
    
that sounds like wrong routing issue where it would use the other network card not reaching the destination and timing out –  Prix Aug 18 '10 at 5:20

1 Answer 1

Could be a routing issue - if you only plug in one of the two network cards, are the routes set so they all go via the one, connected network card? If not, that's likely to be your problem.

share|improve this answer

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.