Take the 2-minute tour ×
Server Fault is a question and answer site for professional system and network administrators. It's 100% free, no registration required.

I've installed Remote Server Administration Tools for Windows 7 because I would like to administer my Windows Server 2008 R2 Server Core machine.

The error that I'm getting when I try to run Server Manager is:

Connecting to remote server failed with the following error message: Access is denied. For more information, see the about_Remote_Troubleshooting Help topic.

This is what I've done so far:

  1. I'm running WinRM service on both machines (Server and Window 7)
  2. I've added my server to trusted hosts on my Windows 7 machine:
    winrm set winrm/config/client @{TrustedHosts="WINSRV2"}
  3. I've added registry entry on Windows 7 machine:
    reg add HKLM\SOFTWARE\Microsoft\Windows\CurrentVersion\Policies\System /v LocalAccountTokenFilterPolicy /t REG_DWORD /d 1 /f
  4. I've enabled Remote Management inbound rule on server firewall using CoreConfigurator 2.0
  5. both machines are in the same subnet and when I search for network machines on Windows 7 I see my server.
  6. I've run Server Manager on my Windows 7 machine normally as well as elevated but with no obvious difference. Same error returned.

Before I've executed 2 and 3 I was getting a completely different error, that was even more ambiguous. At least I got to this point where machines are obviously trying to communicate.

Question

What else should I do to make it work? I would like to run several different remote management tools against my server machine.

share|improve this question
add comment

2 Answers

Configure the windows firewalls on both sides ;)

share|improve this answer
    
As stated in my question I've configured firewall on the server side. I guess that's all that should be configured there. What about the client side (Windows 7 machine)? What should be configured there? –  Robert Koritnik May 30 '10 at 6:09
add comment
up vote 0 down vote accepted

Resolved

I had to run remote management tools under domain admin account. They connected just fine to my domain controller on Windows Server 2008 R2 Server Core. This was stupid, yet I learned something... ;)

share|improve this answer
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.