Take the 2-minute tour ×
Server Fault is a question and answer site for professional system and network administrators. It's 100% free, no registration required.

Our MPLS provider needs our routers to be setup with modems so that they can dial in and make config changes when necessary. I have connected the modem to the router (Cisco 2600) via the aux port. When I dial the # for the modem, it rings, but never answers. I'm guessing there's something in the router config that I need to setup, but I have no idea what it is. Any ideas?

share|improve this question
    
what kind of modem? –  SpacemanSpiff Dec 4 '10 at 6:48

2 Answers 2

up vote 1 down vote accepted

The laziest way is almost certainly just to go:

async-1#terminal monitor
async-1#debug confmodem
Modem Configuration Database debugging is on
async-1#configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
async-1(config)#line 1
async-1(config-line)#modem autoconfigure discovery
async-1(config-line)#

The real answer is set &S0=1 in your modemcap (well probably) Actually you probably want to look at the whole list of vendor init strings http://www.cisco.com/en/US/tech/tk801/tk36/technologies_tech_note09186a008009428b.shtml#specinitialcomm (that page also has some info on creating a chatscript and altering modemcaps)

share|improve this answer

A couple of things to verify:

  • you are use a cisco roll-over cable
  • the modem speed
  • what TTY number is your aux port
  • configuration of your aux port

Additional information: Configuring a Modem on the AUX Port for EXEC Dialin Connectivity

example:

line 65   
 modem inout
 speed 115200  
 transport input all
 flowcontrol hardware
 login
 password cisco
share|improve this answer

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.