I can't figure out iptables and I don't know very much about networking and I'm really hoping that someone out there can help me.
I have a server with two ip addresses associated with it: 220.127.116.11 and 18.104.22.168
Running Ubuntu 10.04
Here is my ifconfig:
eth0 Link encap:Ethernet HWaddr 00:16:3e:xx:xx:xx inet addr:22.214.171.124 Bcast:xxx.xxx.xxx.xxx Mask:xxx.xxx.xxx.xxx inet6 addr: xxxxxxxxxxxxxxxxxxxxxxxx Scope:Link UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:8601280 errors:0 dropped:0 overruns:0 frame:0 TX packets:2520243 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000 RX bytes:1736805563 (1.7 GB) TX bytes:412953236 (412.9 MB) Interrupt:11 eth0:0 Link encap:Ethernet HWaddr 00:16:3e:xx:xx:xx inet addr:126.96.36.199 Bcast:xxx.xxx.xxx.xxx Mask:xxx.xxx.xxx.xxx UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 Interrupt:11 lo Link encap:Local Loopback inet addr:127.0.0.1 Mask:255.0.0.0 inet6 addr: ::1/128 Scope:Host UP LOOPBACK RUNNING MTU:16436 Metric:1 RX packets:1216209 errors:0 dropped:0 overruns:0 frame:0 TX packets:1216209 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:0 RX bytes:13294196379 (13.2 GB) TX bytes:13294196379 (13.2 GB)
Everything works fine: when I type 188.8.131.52 or 184.108.40.206 into the address bar of a browser, I get the default Apache2 page as expected.
Now, I have an application that runs in the browser which has a WebSocket connection over port 8000. I serve the page over port 80 (http) as usual using 220.127.116.11, and I have the WebSocket communicating behind the scenes with 18.104.22.168 over port 8000. Everything's fine.
Now I plug in my 3G modem which blocks port 8000. My WebSocket communication to 22.214.171.124 fails.
I want the WebSocket to communicate with 126.96.36.199 over port 80, but get the server to translate requests on 188.8.131.52:80 to 184.108.40.206:8000.
I can't do this!
I found this: meteorserver dot org/installation/ (see section 6) but it didn't work ;( I also tried this: http://www.cyberciti.biz/faq/linux-port-redirection-with-iptables/ but it gave me the following error:
ubuntu> sudo iptables -t nat -A PREROUTING -i eth0:0 -p tcp --dport 80 -j REDIRECT --to-port 8000 Warning: weird character in interface `eth0:0' (No aliases, :, ! or *).
Apparently IP aliases aren't supported ;( I tried putting eth0:0 in quotes and it still wouldn't work.
I'm completely stumped.
Any help much appreciated.
Thanks in advance,