Take the 2-minute tour ×
Server Fault is a question and answer site for professional system and network administrators. It's 100% free, no registration required.

We have a tone generator kit for tracing network cables, but I am having trouble using it correctly.

The tone generator end plugs into the network cable I am trying to trace, and then I assume I should be able to go into the server room and just swipe the probe across the ends of the patch cables while still plugged into the switch, and hear the tone, but that doesn't seem to work.

  • When the probe is pointed directly at the tone generator, it responds correctly.
  • When I point it a few inches down the wire that is connected to it, it does not respond. I suspect this is due to the cable shielding? As a result, I assume I need to point at the cable end, and not the middle of the wire in the server room.
  • My understanding is that the probe does not require you to un-plug any cables to work. Is this correct?

It would be great if someone who knows what they are doing would document the correct procedure here.

Thanks.

share|improve this question
add comment

5 Answers

up vote 4 down vote accepted

First, check the batteries or make sure that you have new ones. Next, you should be swiping along the patch panel and not the switch. I swipe along the underside of the cable jacks (against the copper side) or along the punch panel on the back. I usually get a clearer signal this way.

I think you should test your toner by plugging the generator into a line you know is patched properly and stick the receiver in the proper jack.

share|improve this answer
    
Thanks - swiping along the back of the patch panel did the trick. Unfortunately it's a pain to access! –  Brent Jun 4 '09 at 16:53
add comment

You can trace the cable that is plugged into a switch or server but you must ground the black alligator clip that come off the tone generator. Any large metal object should do the trick.

share|improve this answer
add comment

If you are tracing a data line, you have to disconnect the patch cable from the server to the patch panel. If you do not disconnect the patch cable, you will get no signal from the tone generator. The server interferes with the signal. Also, mentioned above, make sure the batteries are good in the tool.

share|improve this answer
add comment

The 'wand' end of the tone generator usually has a 'gain' adjustment. Make sure you adjust this appropriately for your environment. It depends on physical contact with the copper if the signal is faint, although I've traced wires across an entire building and not needed

When you have a lot of interference (active network connections) or jacketed / interference-resistant cable, you're going to need conductive contact between the wand and the actual wires inside the cable.

share|improve this answer
add comment

My experience with tone generators is that you're going to be touching the pins on the jacks on the patch panel, or, if you've got a really sensitive probe, the terminations on the back of the patch panel. I've never used a tone generator / probe combination that was able to pull tone thru the insulation of a UTP cable.

I don't know that I'd plug a tone generator into the far end of a cable that's patched into a switch, either. You probably won't blow anything up, but I wouldn't try it.

share|improve this answer
    
I've got a fairly low end "fox and hound" that I've used to find a cat5 cable inside a wall through sheetrock. I couldn't tell you it was two inches to the left or anything, but I could tell you that cable run somewhere near a given section of wall. I got a faint sound, but it worked. –  kbyrd Jun 4 '09 at 16:33
1  
Yeah-- I'm reading about some of them here working thru walls. Wild. Apparently the one I have is crap, because I know it can't do that! smile –  Evan Anderson Jun 4 '09 at 16:56
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.