2

I am trying to configure a roadwarrior scenario between a linux box with StrongSwan and a Windows Box with Agile VPN. I successfully configured my StrongSwan and my Windows box to connect. The Windows box also gets an IP from the Virtual IP pool and the SA is visible on the StrongSwan server. The "only" issue is, that I cannot ping through the tunnel. Not even directly between the gateway and the rw. On the Windows box I see the additional network device in ipconfig and route, but on the linux machine i cannot see anything.

My ipsec.conf:

config setup
nat_traversal=yes
plutostart=no

conn %default
keyexchange=ikev2
ike=aes256-sha1-modp1024!
esp=aes256-sha1!
dpdaction=clear
dpddelay=300s
rekey=no

conn win7
# left=%any
left=%defaultroute
leftsubnet=0.0.0.0/0
# leftsubnet=10.6.0.0/24
leftauth=pubkey
leftcert=ipsec.crt
leftid=@XXXXX
right=%any
rightsourceip=10.6.4.0/24
rightauth=eap-mschapv2
rightsendcert=never
eap_identity=%any
auto=add
pfs=no

0

You must log in to answer this question.

Browse other questions tagged .