Take the 2-minute tour ×
Server Fault is a question and answer site for system and network administrators. It's 100% free, no registration required.

I have a feeling this is pretty obvious but I can't figure it out.

I have a Server 2008 (No Hyper-V) installed with dual NICs, both on the internal network.

One identifies with the domain fine and gets an IP, the other does not. Assigning a static IP doesn't help and I can't ping it when I do assign a static IP.

The 2nd NIC was added after the 2008 setup and initial install but has all the correct drivers. Any clues?

share|improve this question

1 Answer 1

  1. Faulty NIC
  2. The switch it's connected to is locked down to only serve white-listed MAC addresses

Ways to test both of them: Plug the NIC into something else, either directly into another computer (eg laptop), or into dumb switch, and manually configure the IP addresses and see if you can talk directly to the other computer.

Pinging is often not a good test of network connectivity though as ICMP packets could be blocked for whatever reason.

share|improve this answer
    
3. The NIC doesn't have a cable plugged into it, or the cable is bad. –  Chris S Jun 5 '11 at 14:05

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.