Has anyone else gotten it to work?
My setup:
Router: Netgear WNR3500v2
WAN IP: y.y.y.y
Radius: off
Wireless Security:
Security Mode: WPA2 Enterprise
WPA Algorithms: AES
Radius Auth Server Address: x.x.x.x
Radius Auth Server Port: 1812
Radius Auth Shared Secret: password
Key Renewal Interval (in seconds): 3600
TekRadius Server:
Users:
test (username), User-Password (check): 1234, TLS-Server-Certificate (check) [created with TekCERT]
Clients:
Default (NAS), password (secret)
y.y.y.y (NAS), password (secret)
Settings:
Service Parameters:
Listen IP Address: x.x.x.x
Authentication Port: 1812
PEAP Inner Auth Method: EAP-MS-CHAP-v2
Computer Trying to Authenticate: Mac: 10.6.5
Recognizes that the auth needs user/pass.
I type in test and 1234, nothing happens, it asks again.
Sometimes it "connects" says its authenticating,
and then disconnects, and then repeats.
Hardware setup: TekRADIUS on Windows 7, plugged directly into the router. Mac, trying to wirelessly authenticate with the netgear and the radius server.
Notes: I've been running wireshark while I've been trying to connect, and applied a filter of 'radius', and no packets have shown up.
In the TekRADIUS log, it shows nothing except when the server starts and stops, and these messages:
12/7/2010 5:06:34 AM - IP address configuration change has been detected
Which is weird, cause the IPs aren't changing.