Take the 2-minute tour ×
Server Fault is a question and answer site for system and network administrators. It's 100% free, no registration required.

Is there a way to move a Raidset configured for a Raid0/1 from a HP DL380G5 with a SmartArray P400 Controller into a DL380G5 with an E200i. When I fit them in the new Server it does not recognize any Raidsets.

share|improve this question

1 Answer 1

up vote 1 down vote accepted

The array should be portable, as in, the array data exists on the disks. Typically, if you keep the drives in the same order (how many disks are there?), maintaining the same drive arrangement, the new controller should recognize the array. If not, try to upgrade the firmware on the destination E200i controller using the Current Smart Update Firmware DVD.

share|improve this answer
    
Funny, I just did this today. Worked fine. I'm using ML350s is the only difference. –  ErnieTheGeek Jan 13 '11 at 21:41
    
i´ll check the firmware on monday - that´s a good hint! –  lepole Jan 14 '11 at 8:51

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.