Take the 2-minute tour ×
Server Fault is a question and answer site for professional system and network administrators. It's 100% free, no registration required.

I currently have two Cisco Cat5505s as the core switches in my network (layer 2 and 3), and we're looking to move over to a new WAN infrastructure, and subsequently re-IP address everything.

At the moment, anything from new IP address range to remote legacy IP attempts to route over the legacy WAN, and is subsequently lost, so I need to route it via the new WAN router whilst keeping the legacy IP address range working as is. All routes are currently defined statically.

Is there any way I can get my traffic to route to the same end point by different routes depending on which source IP, or VLAN the traffic originates from?

Thanks

share|improve this question

1 Answer 1

You need to use route mapping, however the specifics at the moment are eluding me. Look into the command, were you planning to do this all with the switches or specifically with routers?? You can route pretty much based on any policy with route maps.

share|improve this answer
    
As I manage the switches, but not the routers, I was hoping to do it all using the RSM of the switches. –  Mike1980 Feb 10 '11 at 7:02

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.