up vote 0 down vote favorite
share [g+] share [fb]

I have a Brocade FCX-4XG and I'm connected to the serial console. I would like to change the terminal length of this console to facilitate scripting, but unlike a cisco or juniper, it's not terribly obvious how to do this...

FCX648 Switch#term 
  monitor   
FCX648 Switch#
FCX648 Switch(config)#term 
Unrecognized command
FCX648 Switch(config)#
FCX648 Switch(config)#console 
  timeout   Idle timeout
FCX648 Switch(config)#

Any ideas how to do this? The manual doesn't seem to say either.

link|improve this question
60% accept rate
feedback

1 Answer

up vote 0 down vote

I know this is a bit late but if you haven't found an answer yet, the command you are looking for is "skip-page-display" entered from then enable prompt.

link|improve this answer
Thank you Chris, I am not in the lab so I can't check... I will let you know whether this worked tomorrow – Mike Pennington Jan 10 at 6:31
feedback

Your Answer

 
or
required, but never shown
discard

Not the answer you're looking for? Browse other questions tagged or ask your own question.