Take the 2-minute tour ×
Server Fault is a question and answer site for system and network administrators. It's 100% free, no registration required.

vxprint -m -g command in vxvm give lot of inofrmation about the volume like rid , pub offsets etc. Is there a command in solaris volume manager to get the such information?

and vxprint -F %len -g -v gives volume length in blocks. Is there any command in solaris volume manager to get length information?

share|improve this question

1 Answer 1

up vote 0 down vote accepted

Have a look at the metastat command it provides some of the information you appear to be looking for e.g. (from man metastat)

# metastat
 d2: Concat/Stripe
     Size: 204800 blocks
     Stripe 0:
         Device              Start Block  Dbase State        Hot Spare
         d0                         0     No    Okay

 d0: Soft Partition
     Component: c0t3d0s0
     Status: Okay
     Size: 204800 blocks
         Extent              Start Block  Block count
              0                      129       204800

 d3: Soft Partition
     Component: d2
     Status: Okay
     Size: 202752 blocks
          Extent              Start Block  Block count
               0                      129       202752
share|improve this answer

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.