Take the 2-minute tour ×
Server Fault is a question and answer site for system and network administrators. It's 100% free, no registration required.

I have a Dell Power Edge 1850, running Windows 2k3 x86. It has 4 GB of RAM (8 total sticks of 512MB, which I have tried re-seating, and completely replaced with new memory) however this is what I am seeing whenever I look at the Task Manager.

Memory Usage

What is going on here? It appears that it is running with close to 1 GB of RAM but only has 261 MB of physical memory? Does the indicator on the left include the physical memory + the available PF? Is there anything I can do to get windows to recognize the rest of the memory if possible?

Thank you in advance.

Edit: Should have said 6 total sticks of 512MB. With a total of 3072MB.

share|improve this question
    
What's about ram from bios? –  lg. May 16 '11 at 15:27
    
Which PE1850 is this? The Dell documentation for the PE1850 indicate only 6 slots. –  jscott May 16 '11 at 15:38
    
@jscott, my mistake you are correct. 6 slots. So I have 6x 512Mb should be equal to 3072Mb. I ran the tool that @Phil had indicated below, and it does show all 6 sticks at 512Mb. –  aceinthehole May 16 '11 at 17:54

4 Answers 4

Try to boot your PE1850 with DELL diagnostic CD.

share|improve this answer

In some Dell systems, there is a BIOS option for "OS Install Mode". This limits the server to 256MB of physical RAM if it is enabled.

share|improve this answer
    
+1 for that being a very logical reason. Half a stick is an odd size otherwise - sticks normally fail TOTALLY. Worth a check. –  TomTom May 16 '11 at 18:04

Defective hardware (Motherboard?) or incompatible bios (does not olike the memory). Point. 261mb memory is less than one stick. SHould not be like that.

share|improve this answer

When you boot, you should be shown how much memory the server can "see" installed.

Also, you can use a tool such as http://www.cpuid.com/ to check if the OS can see the sticks of memory installed.

If either of these don't show 8 x 512Mb then I suspect some of the memory is duff.

If all 8 sticks show up then its likely that the OS itself isn't allowing you access to it all. I know that on Windows XP we would only see about 3.4GB with 4 x 1GB installed, not sure about Windows server though

share|improve this answer
    
I was incorrect about the number of slots I had 6x 512 Mb. I ran the tool you suggested and it is showing all of the sticks that I suspect. –  aceinthehole May 16 '11 at 17:55

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.