Take the 2-minute tour ×
Server Fault is a question and answer site for professional system and network administrators. It's 100% free, no registration required.

I am currently setting up a new infrastructure with HP 2510s as edge switches and an HP E5406 as the main switch. I also have a DHCP and DNS server running on the same network.

When i first set up one of my 2510 switches, I gave it a static IP through the console and then went to the web interface to continue my configuration. Later, I realized that I assigned it the wrong IP address, so i went through the web interface and changed the IP address to the correct one.

Now, I can't access the web interface. I can telnet to the switch on the new IP address, but the web interface will not load. If I switch from static IP to DHCP, it loads the web interface. Any ideas on what could be causing the web server in the 2510 not to load with the new static IP address?

share|improve this question
1  
What firmware (show ver)? I assume you've power cycled it? Do you have an vlans defined? –  Chris S May 19 '11 at 23:20
    
I'm running Y.11.16. I never actually power cycled the switch, but I have reboot it a bunch through the console. –  Stephen May 20 '11 at 2:51
1  
I've got 25010Gs and had problems with T.11.16 that HP still hasn't resolved. I ended up reverting to Y.11.12. –  Chris S May 20 '11 at 13:05
    
Well, i powered cycled the switch and now everything is working. Thanks for the suggestion. –  Stephen May 20 '11 at 21:54

2 Answers 2

This is a known bug in the firmware. Just go back to the old version.

share|improve this answer

You may need to powercycle for it to take the new settings into effect for all the management interfaces.

share|improve this answer

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.