Take the 2-minute tour ×
Server Fault is a question and answer site for system and network administrators. It's 100% free, no registration required.

I recently fubared the public interface to an SSH connection. I'm trying to set up a NAT that will forward to the eth1 interface with a local address.

The set up is a cisco 3750 -> 3560 switch -> servers. All hosts are pingble via the router.

The NAT is being set up similar to this:

int fa0/0.1
ip address 10.0.200.1
ip nat inside

int gig0/0
ip address xxx.xxx.xxx.xxx
ip nat outside

ip nat inside source list 1 interface GigabitEthernet1/0 overload
ip nat inside source static tcp 10.0.200.150 22  xxx.xxx.xxx.xxx 22 extendable

access-list 1 permit 10.0.200.0 0.0.0.255

With show ip nat translations I can see the mapping. When the public IP is nmap'd it comes up as 22/filtered and I'm not allowed to connect.

With lft(layer 4 traceroute), i.e. lft <ip>:22 the router and the switch behind it return nothing but the server comes back with open.

Its as if the NAT almost works.

share|improve this question

migrated from stackoverflow.com May 25 '11 at 20:06

This question came from our site for professional and enthusiast programmers.

1 Answer 1

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.