Take the 2-minute tour ×
Server Fault is a question and answer site for professional system and network administrators. It's 100% free, no registration required.

We have a new Xerox 6121MFPN laser printer in the office. We use network printing, so this printer is connected to a Linksys WAG320N router (to port 1, if it matters).

When we do not print anything for a while, in 5 minutes the printer goes to sleep. The 5 minutes is a config parameter of the printer.

The problem is that even after we do not print anything for a long while (and no incoming faxes or scan jobs, etc), the printer wakes up every 15 minutes, warms up, waits for 5 minutes (since there's no print job) then goes back to sleep.

We can not figure out why it is waking up, it is quite annoying. If I disconnect the Ethernet cable to the printer, it no longer wakes up. If I connect the network cable but turn off the WAG320N, it no longer wakes up. My guess is that the printer is waking up due to a computer doing some sort of status check or query, but I can not be sure.

All our machines are Win 7 machines, connected wirelessly to the same router.

Update-1 (edit): I added a firewall rule to block all requests from my computer to the printer and make a log of the requests. Turns out, at every HH:MM:55, HH:MM:05 and HH:MM:15, there is a UDP packet transmitted to the printer, from source port 60732 to destination port 161.

And, approximately every 20 minutes, there is a TCP packet from port 60691 to port 139 of the printer, followed by 2 UDP packets from port 137 of the PC to port 137 of the printer. Any ideas of what these might be?

share|improve this question

2 Answers 2

up vote 3 down vote accepted

Good work with the firewall setup/test by the way, smart thinking.

161 is SNMP, 137/139 are Netbios packets - so unless your machine needs an SNMP service (I doubt it needs a Netbios one at all) then you could turn off those two protocols on you machine and hopefully that should be the end of it.

share|improve this answer
    
I turned off NETBIOS from TCPIP network properties of the network adapter and so far, no wake-ups! Keeping fingers crossed. I think that was it. Thanks. Will update the thread if I confirm this solves the problem –  SomethingBetter Jun 1 '11 at 11:41

This is a multi-function printer according to a quick Google (and the "MFP" in the name kind of suggests that too) so it's likely you have an agent installed as part of the Xerox driver/software suite that's periodically polling the printer; probably for the Scan-to-PC functionality or perhaps to check toner levels (SNMP).

There may be an option/setting as part of this software suite something to the effect of "poll printer every x seconds," so you can quiet it down, but dropping egress packets on your workstation(s) to the printer might kill the scanning/management functionality.

share|improve this answer
    
That's what I suspected too. I turned off Scan-to-PC functionality and killed the related background processes running on my PC. The printer would still wake-up unnecessarily. Turning off NetBIOS seems to solve my problems. –  SomethingBetter Jun 1 '11 at 11:37
    
On another note, when the printer is asleep, it still responds to pings, which makes me believe that its network interface never actually goes to sleep, ie, it is not a traditional wake-on-lan device. (This observation is based on my limited knowledge of wake-on-lan though :) –  SomethingBetter Jun 1 '11 at 11:38

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.