Take the 2-minute tour ×
Server Fault is a question and answer site for professional system and network administrators. It's 100% free, no registration required.

I have an old IBM x206 with Ultra 320 SCSI drives, the motherboard died and Im not replacing it but the data on the drives is still important.

I dont have another similar server to hand, is there some kind of enclosure / caddy that can read SCSI drives

Any product suggestions or alternate ways to read data from SCSI drives appreciated. Obvioulsy the cheaper the solution the better as I cant get any budget for third party recovery.

share|improve this question
add comment

1 Answer

up vote 3 down vote accepted

If the drives are not in any kind of raid config the cheapest option is to just buy a used scsi controller, likely you can snag one for under $50 off ebay, plug it in to a PC and migrate your data off.

share|improve this answer
2  
If the drives were hot swap you'll probably also need an SCA-LVD adapter to convert the 80 pin hot swap connector to 68 pin which you can use with a regular internal SCSI controller. –  James Yale Jun 1 '11 at 16:22
    
Yes the drives are hot swap and also RAID in this case just a mirror so a single drive solution via a used controller and adaptor should be fine, but what about RAID 5 arrays which I have lots of? –  Marko Jun 3 '11 at 8:16
1  
Depending on the raid 5 arrays you can sometimes just replace the controller with the same model controller and you'll be fine. If its a funky onboard controller you'll likely just need to get a whole new motherboard if you cant find a card to match. –  ErnieTheGeek Jun 3 '11 at 13:23
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.