Take the 2-minute tour ×
Server Fault is a question and answer site for professional system and network administrators. It's 100% free, no registration required.

I want to move our old LTO 2 tape drive down in order so our new LTO3 is the primary backup and if for any reason the LTO3 fails then at least I can backup critical data using the LTO2.

I have moved the LTO2 tape drive down to the 2nd plug but neither of them are visible at POST.

I assume I have missed something with either the jumper settings (if I need to do them) or the SCSI ID.

The SCSI card is an LSI Ultra320 2000 series w/1020/1030.

I have also tried with the LTO2 drive connected only to the 2nd termination and the LTO3 disconnected but still not showing in POST.

share|improve this question
    
Sounds like you've simply messed up your SCSI cabling/jumpers/termination - we'll need a LOT more information if you want us to help - do a full braindump ok. –  Chopper3 Jun 15 '11 at 12:56
    
You tell me what you need to know and I'll gather it. Is it just jumper information you need? –  Alex Wilden Jun 15 '11 at 13:00
    
Just everything you can, controller config/settings, physical cabling layout, exact make/model of devices, jumper settings, where any terminators are, server make/model/OS etc. –  Chopper3 Jun 15 '11 at 13:10
    
Oh and by the way I pass your office twice a week, I do a lot of my work for BT and when I'm there stay about .5km away from you - small world eh –  Chopper3 Jun 15 '11 at 13:11

1 Answer 1

If the LTO2 was list at POST, the LTO3 should be listed too. Checks that no pin is bended. Use the same cable than the LTO2 Try with and without SCSI terminator(particularly with HP drive)

Does the Two drive from the same manufacturer ? Does the LTO2 works on the 2nd plug ?

share|improve this answer

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.