Take the 2-minute tour ×
Server Fault is a question and answer site for system and network administrators. It's 100% free, no registration required.

I have Cisco 3600 router, and a few SLA monitors configured. Based on these monitors, I make a decision where to route users (basically a failover).

It works very smooth and nice, to the point where no one notices when one of the connections goes down. I just discovered that one of our internet connections was down for about a week!

So naturally I wanted to set up a monitor for that condition. Natural choice is SNMP. I Started digging for OIDs, and have a really hard time figuring out what would be the correct OID (how to find that OID) for my SLA monitor. Found OIDs for interface, but interface is always up, even if the connection is down (unless it is physically unplugged ot power is off on the other end).

So the question is how can I find out what would be an OID for SLA monitor so that I can see the same things "show track" does on a remote computer?

share|improve this question

1 Answer 1

up vote 0 down vote accepted

There is the command snmp-server enable traps rtr to enable traps regarding SLA Monitor and the RTTMON MIB to pull data. I recommand you to read http://www.cisco.com/en/US/technologies/tk648/tk362/tk920/technologies_white_paper0900aecd8017f8c9.html (search for snmp) and http://tools.cisco.com/Support/SNMP/do/BrowseMIB.do?local=en&mibName=CISCO-RTTMON-MIB

share|improve this answer

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.