I am configuring Cisco Wireless Lan Controller.
Cisco has only one active port (1) where is attached management interface.
Management interface has ip address, for example:
213.12.12.12
and as a gateway has
213.12.12.1
I created one dynamic interface, called vlan90, also on port 1 with IP address 10.10.2.2. However, I am not sure what I should set as gateway - I tried to setup 213.12.12.1 as a gateway for vlan90 (hoping that there should be internal routing between my virtual interface and management one), but I got message about network addresses problem. So I put the IP of non existing machine, 10.10.2.1.... Which is not correct, but allowed me to save interface.
I have set up my WLAN (I am able to connect with my laptop). I am getting IP (10.10.2.20), however, I am not able to ping even router... What I should do to:
I want to handle users trough then working WLAN, and I want my users to access internet - the only port connected to internet is "1".
I am not sure how I can set traffic coming from virtual interface to access interface trough the port...
