Take the 2-minute tour ×
Server Fault is a question and answer site for system and network administrators. It's 100% free, no registration required.

I have seen videos in CBT nuggets for ccnp and ccna. The instructor always uses show run | section eigrp and it looks very good command

But i am trying that in GNS , it says command not found

How can i use that

share|improve this question

2 Answers 2

up vote 2 down vote accepted

I believe the "selection" filter fetures was added to the show command in IOS 12.3(2)

Show Command Section Filter

There are some other useful filters which may work as an alternative sh run | ?

share|improve this answer
    
i am using gns which has 12.2 ios , how can i upgrade it –  Mirror51 Aug 11 '11 at 8:51
    
You need a valid Cisco SmartNET contract to download a newer version of router IOS. –  HampusLi Aug 11 '11 at 16:45
    
@Mirror51 See serverfault.com/questions/286620/… –  Shane Madden Aug 11 '11 at 16:58

Shouldn't you be using

show run | begin router eigrp

As far as I know that is the command to view the running config lines relating to eigrp configuration. That should pretty much work on all IOS'es.

share|improve this answer

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.