Take the 2-minute tour ×
Server Fault is a question and answer site for professional system and network administrators. It's 100% free, no registration required.

Apologies if there is a better site.

I have DAP-1360 and another router connected to an office switch, which connect to the internet router.

I would like the two wireless devices to act as access points, but to be seen as the same network (there is an area of overlap of the signal).

DAP-1360 supports: AP Mode, Wireless Client Mode, repeater, bridge, bridge with AP, WISP client router and WISP repeater mode out of the box.

My requirements are satisfied with WISP repeater mode, however in this scenario (I assume, I did not run traceroute) the nodes communicate wirelessly between themselves, too, and there is available router over wire.

Related question that seem to have an answer is here. The answer is from 2009 and I was wondering if it is still the case that different channels and same ssid is a recommended, standard solution?

share|improve this question
add comment

1 Answer 1

up vote 1 down vote accepted

Configure them in AP mode and then do what the answer on that link says. I.e.:

Just set each router to use the same SSID but a different channel. Users will see it as a single wireless network when they move between floors. The different channels will ensure that the routers do not conflict with each other.

And that should be the lot.

share|improve this answer
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.