Take the 2-minute tour ×
Server Fault is a question and answer site for system and network administrators. It's 100% free, no registration required.

I have a dedicated server, which is currently running Windows 2008 R2 Web edition and VMWare Server. I am upgrading to Windows Server 2008 R2 Standard with Hyper-V. Once upgraded, it will have 24GB of RAM and a four core Core i7 processor. At the moment, it runs IIS on the main system instance, and has a Linux VM. The Linux VM has a dedicated IP given to it, and the host has 2 IPs.

Once the upgrade is complete, I would like to move the Web hosting to a VM on the machine under Hyper-V, and also move the Linux box to Hyper-V. This will mean that both VMs have a public facing IP as does the box itself. I am currently limited to 3 public facing IPv4 addresses, but have a /64 IPV6 block.

If I want multiple VMs, some public (web sites, etc) others not (development boxes) how do I do it? I know that I can just set up a reverse proxy and give that a public IP and give the resources behind it private IPs. Is that the best solution?

share|improve this question

3 Answers 3

up vote 4 down vote accepted

I have exactly the same issue - my answer was to run ISA Server as a VM too (I know this is normally frowned upon) to handle the inbound requests and route to the correct server (all using internal IP addresses).

share|improve this answer
    
sounds like a posibility... need to look into this. thanks for the tip. –  TiernanO Nov 4 '11 at 11:49
    
+1. ISA (or apache with mod_proxy) are both good options to solve this issue. A reverse proxy was the first thing that came to my mind as well. –  MDMarra Nov 4 '11 at 13:21
    
Cool. going to look into ISA and see what i can get it to do. –  TiernanO Nov 4 '11 at 14:31
    
@TiernanO ISA has been re-branded as Forefront Threat Management Gateway (TMG). For new installations, you should be looking at that. –  MDMarra Nov 4 '11 at 14:36
    
thanks @markm Will look into that now. thanks! –  TiernanO Nov 7 '11 at 9:07

You router should be able to do NAT and port forwarding. And use the private address range for your servers.

share|improve this answer
    
I dont have my own router infront of the server. –  TiernanO Nov 4 '11 at 14:30

Use private IP address for your servers. And you may hava a mapping between public and private IP address. You may to use one linux for this and its free.

In other case you may use CISCO ASA, mikrotik , TMG server . etc ..

share|improve this answer

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.