I'm trying to compile kernel-rt-220.127.116.11-rt31.75.el6rt.src.rpm from RHEL6 MRG source RPMs on Centos 6 x86_64 system.
It's first time I'm doing this, so I did research on how to do this properly. From what I found, I did:
rpm -ihv kernel-rt-18.104.22.168-rt31.75.el6rt.src.rpm cd ~/rpmbuild/SPECS nano kernel-rt.spec rpmbuild -bb kernel-rt.spec 2> build-err.log | tee build-out.log
in kernel-rt.spec I've disbleed compilation of variants I don' need - ie compile only rt and firmware. Also defined not to build debuginfo.
After compilation finished, I've got in
~/rpmbuild/RPMS/x86_64/ two files:
but when I tried to install kernel, I got error message: $ sudo rpm -ihv kernel-rt-22.214.171.124-rt31.75.el6rt.x86_64.rpm error: Failed dependencies: kernel-rt-firmware >= 126.96.36.199-rt31.75.el6rt is needed by kernel-rt-188.8.131.52-rt31.75.el6rt.x86_64
There was no folder ~/rpmbuild/RPMS/noarch - where I would expect it to show up.
Also, I've tried
rpmbuild --rebuild kernel-rt-184.108.40.206-rt31.75.el6rt.src.rpm, but got same results...
What am I doing wrong? I've seen this question, but it suggests what I tried already and I want to build kernel myself, not use pre-built from SLC.