Sign up ×
Server Fault is a question and answer site for system and network administrators. It's 100% free, no registration required.

I want to configure a failover link to my cache server with Cisco policy routing. So I attempted to create an ip sla monitor. here is the syntax in the cisco router (there is possibility of being wrong words in parameters but here I just wanted to show the styles):

R1(config)# ip sla monitor 1
          type tcpConnect destip destport 1010
          timeOut 30
          frequency 30
R1(config)# ip sla monitor 1 schedule life forever starttime now

and then created a track watching for that monitor and use it on routing. But every time I check out the ip sla monitor 1 statistics like this it fails. While I can telnet the with router!

R1# sh ip sla monitor statistics 1

<some stuff here>

last operation return code: No connection
number of success: 0
number of failures: 66

and the track return me the link is down.

Any ideas?

share|improve this question

migrated from Nov 24 '11 at 15:38

This question came from our site for professional and enthusiast programmers.

1 Answer 1

You don't need to use control protocol.

type tcpConnect destip destport 1010 control disable

IP SLAs uses the control protocol to notify the IP SLAs Responder to enable the target port temporarily. This action allows the Responder to reply to the TCP Connect operation. In this example, because the target is not a router and a well-known TCP port is used, there is no need to send the control message.

share|improve this answer

Your Answer


By posting your answer, you agree to the privacy policy and terms of service.