Take the 2-minute tour ×
Server Fault is a question and answer site for professional system and network administrators. It's 100% free, no registration required.

We have a Draytek Vigor 2820 in our office and we have a few servers running websites and email applications. These servers each have their own public ip using WAN aliases that are mapped to their local IP.

I am looking to extend our IP block (from our ISP) from 5 static IP addresses to 15. The problem is, I can't find a medium business type router that supports more than 8 WAN aliases.

Is there an alternative way of routing public IP addresses to local servers that bypasses the 8 alias limit. Or do we need a much more expensive router? Our current router cost about £200. The top Draytek router I found with the same limitation is around £500.

share|improve this question
    
I'm not quite sure what you mean with WAN Aliases - do you mean that your current router only supports 8 external IP addresses? –  Mark Henderson Dec 13 '11 at 23:07
    
Yeah, sorry that may be Draytek specific terminology. –  dannymcc Dec 13 '11 at 23:09
    
@MarkHenderson judging by the question I think he's referring to 1:1 NAT entries. –  MDMarra Dec 13 '11 at 23:11
    
@MarkM yep, that's exactly what I mean. I didn't call it a one to one entry because I thought it was a Draytek term. Stupid, eh! –  dannymcc Dec 13 '11 at 23:12

1 Answer 1

up vote 3 down vote accepted

I've never heard of Draytek. If you get a midrange router from a major vendor like Cisco, Juniper, Extreme, etc, you shouldn't run into these asinine limitations. You get what you pay for.

share|improve this answer
    
Do any of those brands have GUI's? I'm not quite ready to control the router using command line only. –  dannymcc Dec 13 '11 at 23:25
    
I know that Linksys models have GUIs and you can have 8 ranges of IP addresses for 1:1 NAT. So if your internal IP's and external IP's are sequential and all in the right order, you can do it all in one entry. It's a stupid system though. –  Mark Henderson Dec 14 '11 at 1:03
    
@dannymcc I don't know. I don't manage any that do. I wouldn't even know where to begin to look for that since its not a requirement of mine. –  MDMarra Dec 14 '11 at 1:06
    
Thanks for your help, I've solved the problem by routing the IP's using a second subnet on the router rather than using the 1:1 NAT. Thanks! –  dannymcc Dec 14 '11 at 15:20

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.