Take the 2-minute tour ×
Server Fault is a question and answer site for system and network administrators. It's 100% free, no registration required.

We are a small office set up with two PC's out of which one of my PCs runs 24hrs. Its almost equivalent to a small server, but right now we're in need of a server which is why I am planning to keep my machine as well as a server into a single PC.

I've used VMware Workstation to create a powerful Windows Server 2008 within my PC and I want to attach it to my Network Switch through the same PC where I am hosting it. I want to use it almost like a physical server with an IP address and everything so that I can connect from one Pc to the Server directly or my applications can connect to Server straight with the IP address.

How should I do this? Step by step instructions would be appreciated.

Thanks in Advance, Best regards Nelson

share|improve this question

2 Answers 2

https://www.vmware.com/support/ws4/doc/network_configure_ws.html

It varies slightly depending on the version of VMWare Workstation you are using, but:

  • Make sure it's set up as "Bridged" and NOT "NAT" or some other setting.
  • This will present your server on the network "raw" as if it was just another computer on the network, so you can set it up just as if it was a physical computer (DHCP, static IP Address, etc.)

If you move the VM to another computer, keep the same MAC address and it will just be like moving a physical computer.

share|improve this answer

In the VM settings make sure the Virtual NIC is using a VMWare network that is in bridged mode. Then give your virtual machine a static IP inside Windows like you normally would for a physical server.

share|improve this answer

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.