Take the 2-minute tour ×
Server Fault is a question and answer site for professional system and network administrators. It's 100% free, no registration required.

I'm trying to isolate traffic using a VLAN, one of our Linksys SRW2048's and two connections going back to our network from the switch.

Currently I have 3 Vlans, 1 is the default, 2 is for iSCSI, 3 was for General Data. Everything works fine if I leave it on the default - 1.

If I move a PC and one of the connections back to our network onto 3, that PC can't see anything. 1 continues to talk to the network fine.

Both ports in 3 and I have tried them set as Untagged - Access, Untagged - General, and Tagged - General.

Is there a setting I am missing somewhere else?

share|improve this question
add comment

1 Answer

You need to have some kind of inter vlan routing set up. Your switch may provide this. If not a dedicated router would.

share|improve this answer
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.