Take the 2-minute tour ×
Server Fault is a question and answer site for professional system and network administrators. It's 100% free, no registration required.

I've browsed the other related questions, as well as countless Google searches, but nothing seems to fit our unique situation.

We have a Netopia 3347 DSL Modem/Router. The rest of the network is connected to this through a switch and various hubs.

DHCP is turned off on the Netopia, and our Domain Controller handles DHCP.

We have a "quarantine" bench where we would like machines to be able to access the Internet, but restrict their access to the rest of the network.

We have a Linksys E2000 flashed with DD-WRT, and an 8-port Cisco ESW 540 switch to play with for the quarantine bench.

We tried using the Linksys alone, connected to the DSL modem, using the Linksys for DHCP and setup separate VLANs, etc but nothing has worked. We receive one of three results:

  • Machines on the Linksys have access to both the Internet AND network
  • Network access, but NO Internet access
  • No access whatsoever

When we try setting up VLANs on the Netopia, we completely lose access and have to do a complete reset.

We've tried numerous configurations of VLANs and subnets. To be honest, this is a little over my head.

Any suggestions as to the right way to go about doing this?

I may not have provided enough information; if more is needed I will gladly provide it.

Thanks in advance!

share|improve this question
add comment

1 Answer

To me it sounds like you want to create a VLAN isolated from the normal LAN, and your third result of no access whatsover is probably in the right direction.

Once you have this isolated VLAN, you then need to figure out how to route this to WAN without allowing access to your normal LAN.

If for example you use the Linksys in a double NAT setup with your existing Netopia in place, as the WAN side of the Linksys is actually on your general LAN subnet, this will mean you will still be able to access both internet and general LAN from your isolated VLAN. If you did this however, your general LAN would not be able to see the isolated VLAN. If you reversed this setup, it would achieve what you want, but your general LAN would be double NAT'ed which may not be desireable.

Unfortunately it been a very long time since I'm played with DD-WRT but I'm wondering if in the setup I described, you could firewall access to everything on it's WAN side (i.e. your general LAN) except the router.

share|improve this answer
    
Thanks, at least we're somewhat on the right track! I'm hoping someone can give a few more details as we are at a total loss. –  J.R. Mar 8 '12 at 21:09
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.