Take the 2-minute tour ×
Server Fault is a question and answer site for professional system and network administrators. It's 100% free, no registration required.

I need to create a VPN IPsec tunnel between my Windows 2008 R2 server and a CISCO ASA device.

I want my server to be both the end of the tunnel, and the server that connects to the other side (no need to connect a whole subnet, just the server would be fine).

I found this article that seems to do the trick, but there are two differences:

  1. As mentioned above, the computer behind my end is the server itself. Can that be configured? (i.e. make the "computers in endpoint 1" IP address be the same than "local tunnel computer").
  2. This article is for Juniper ScreenOS, not for CISCO ASA, though configurations look very similar.

Would that configuration work for me?

share|improve this question
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Browse other questions tagged or ask your own question.