Take the 2-minute tour ×
Server Fault is a question and answer site for system and network administrators. It's 100% free, no registration required.

I am trying to check/change my network card speed settings with RedHat 5 and a Proliant G6 server from HP.
On eth0 I can not really use ethtool - it just says Link detected. The network card is a Broadcom NetXtremee II BCM5709.
Is there any other tool from HP for this task.
The output of setting the speed is:"Can not get current device settings: Operation not supported - not settings speed not setting duplex".

share|improve this question
    
Why can't you use ethtool? What options did you use and what was the output? –  Bram Apr 19 '12 at 6:32
    
I have updated the output/error message. –  weismat Apr 19 '12 at 6:34

2 Answers 2

up vote 1 down vote accepted

In my experience, some NIC's work with ethtool, others with mii-tool. Both have approximately the same functionality. That is, see if mii-tool works for your card.

share|improve this answer

What is the minor version of RHEL 5 ? There are a lot work done for Broadcom NetXtremee II BCM5709 in the kernel shipped with RHEL5.6 and higher. Upgrade the kernel by using following commands

yum update kernel ----->> if system is registered to RHN.

Else download the kernel and install using

rpm -ivh latest_Kernel_rpm

DO NOT use "rpm -Uvh" command

share|improve this answer

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.