Take the 2-minute tour ×
Server Fault is a question and answer site for professional system and network administrators. It's 100% free, no registration required.

I was installing the Suse Linux 11 on HP Proliant DL 380 G7. during installation i got the error " NO usable hard disk found " i got stuck for last 4 days ..need help on prioroty,

share|improve this question

closed as not a real question by Jeff Ferland, jscott, Wesley, Khaled, MDMarra May 13 '12 at 18:20

It's difficult to tell what is being asked here. This question is ambiguous, vague, incomplete, overly broad, or rhetorical and cannot be reasonably answered in its current form. For help clarifying this question so that it can be reopened, visit the help center.If this question can be reworded to fit the rules in the help center, please edit the question.

    
Did you contact HP Support? –  jscott Apr 26 '12 at 17:46

2 Answers 2

The HP ProLiant DL380 G7 uses a Smart Array P410 RAID controller. That version of SuSE may load either the cciss driver or the newer hpsa driver. Either way, both drivers are well-established and available to the system.

Did you create a RAID array/logical drive in the BIOS before booting the system?

As the system goes through its initialization sequence, you'll be presented with an option to hit F8 to configure the Smart Array P410 controller in the system. This enters the Option ROM Configuration for Arrays (ORCA) utility. Create an array of an appropriate RAID level. The instructions for using this interface are on page 10 of the Smart Array support manual. Save the changes and start your SuSE installer.

share|improve this answer

An HP Proliant DL 380 has an on-board RAID controller that requires a specific driver module to use it, namely the HP/Compaq SmartArray cciss driver.

You need to load that before the OS can see the drives; if you have access to an emergency console during installation, run the following:

modprobe cciss
dmesg | tail
share|improve this answer
2  
Include, load, whatever... +1 for conveying what I was aiming for. –  Jeff Ferland Apr 26 '12 at 15:12

Not the answer you're looking for? Browse other questions tagged or ask your own question.