Take the 2-minute tour ×
Server Fault is a question and answer site for system and network administrators. It's 100% free, no registration required.

I want to send a Non-Maskable Interrupt (NMI) to the system over the HP iLO2/3 cli. Unfortunately I don't know the correct syntax or target:

hpiLO-> nmi

status=2 status_tag=COMMAND PROCESSING FAILED error_tag=COMMAND SYNTAX ERROR You must specify an NMI target.

Maybe you can help me out, thanks in advance!

share|improve this question

1 Answer 1

up vote 1 down vote accepted

Type nmi server at the "hpiLO->" prompt to generate an NMI to the system via the CLI.

"server" is the target requested in the error message you posted.

share|improve this answer
    
thank you, it works. The help page only displayed '/system1' and '/map1' as targets... –  Milde May 8 '12 at 13:30

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.