Take the 2-minute tour ×
Server Fault is a question and answer site for professional system and network administrators. It's 100% free, no registration required.

We have a 10 gb fiber run between 2 buildings about a mile apart and will not be able to purchase any more fiber. I was told I could use four "10 gigabit bidi's" to allow 2 separate ethernet connections over the same pair of fiber. These connections will be going to two separate, adjacent switches on each end. I need more information about this as my internet searches have not resulted in any good information about these devices.

share|improve this question
    
Wow. 10Gbps isn't enough bandwidth? –  joeqwerty May 16 '12 at 21:37
2  
I've only ever known BIDI to be an acronym for Bi-Directional –  Mark Henderson May 16 '12 at 21:48
    
What Mark said. At the risk of stating the obvious, why are you not asking the person who made the comment precisely what they were referring to. Either they have a specific product in mind, so go with that, or they were just moving their lips to see what it felt like to exercise the muscles in their mouth and you should speak to someone competent instead. Either way, you've moved forward. –  RobM May 16 '12 at 21:50
    
Another note - the device that you're looking for is called a multiplexer. A multiplexer permits multiple discreet signals over the same set of fiber. They usually involve time sharing of the fiber, which results in lower total bandwidth. –  Mark Henderson May 16 '12 at 22:09
add comment

2 Answers

up vote 4 down vote accepted

What you're probably looking for is CWDM. This allows you to transmit and receive on the same strand of fiber on different wavelengths of light. You would need to purchase a CWDM mux and compatible transceivers for your routers. This is the cheaper version for transmitting and receiving a 1gb link over a single strand of fiber without requiring a CWDM mux. I have only used this method for gig links and haven't been able to find any CWDM 10gig compatible transceivers.

share|improve this answer
add comment

CWDM usually refers to 1G Ethernet or 1/2/4 G Fibre Channel. To pass 10GE you will want some sort of EWDM or possibly a passive DWDM setup. You will end up with single mode LR optics that emit light at a certain specific wavelength which connect to a passive device that, in turn, connects to your inter-site fiber. At the other side the wavelengths will break out to connect to your remotes.

The EWDM solution I mentioned is Cisco (http://www.cisco.com/en/US/docs/interfaces_modules/transceiver_modules/installation/note/78_17894.html) and can handle up to 8 10GE (and another 8 CWDM links) on a single pair of strands, but there are plenty of other comparable solutions out there. The big money is in the optics themselves rather than the actual multiplexer.

share|improve this answer
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.