I plan to setup RAID10 using SSD drives.
What RAID controller comes with the HP DL360 G7?
Is it a real Hardware RAID controller?
And it is compatible with CentOS Linux?
Will SSD be ok in RAID10?
The controller is Linux-compatible and uses a driver that has been in the Linux mainline kernel for over a decade. Depending on your specific OS choice, you will end up using the older CCISS driver or the newer HPSA driver.
As for SSDs, I've used a wide variety with HP Smart Array controllers. The only drives that cause problems are some SATA SSDs whose firmware do not report a valid temperature to the controller and some STEC ZeusIOPS SAS enterprise SSDs that give bogus S.M.A.R.T. errors.
I have a new DL380 G7 going into production running CentOS 6.2 and a Smart Array P410 controller with a RAID 1+0 comprised of OWC Mercury Pro drives (Sandforce controllers).
The specific disk detail is below. Some things don't work. These are 6G drives reporting at 3G. The wear-indicator functionality does not work. However, temperature is reported correctly and all other RAID/Smart Array features work properly:
All HP business gear has a quickspecs page that covers, briefly, all that it includes.
Be warned that using non-HP disks (SSDs included) with a HP SmartArray is not supported and may not work (though they typically do), and there may be performance losses (which is common with mismatched equipment).
It depends on the exact model; entry models come with the P410i/zero-memory, base models come with the P410i/256MB, performance models come with the P410i/1GB and CTO models can have anything from P212/zero up to P812/1GB.
It is indeed very real hardware RAID, though you will want to install the full driver set to ensure you can continue to config the controller and its array/s from within the OS and get access to alerting.
It is RHEL (thus Centos) compatible and it's the RHEL driver set you'll want to install.
As for SSDs, R10 is great, I use it extensively BUT I will caveat that by saying that I use HP branded SSDs, non-branded ones aren't supported but there's a lot of evidence to suggest they work fine although some of the more advanced diags and alerting may not function entirely correctly.
HP DL 370 G7 comes with P410i and it's well compatabile with Centos 6, but make sure you load latest firmware on it, to avoid SSD issues (firmware >5.0). Also it's better to buy 512MB or 1GB version (with extra RAM module), so it supports all levels of RAID. It will be OK in RAID-10, however it's best to limit the number of drive flushes to minimum, especially if you do some logging, e.g. writing each block 20 times will wear them off in 1 year.