6

I have cisco, zte, huawei routers..How can i get the traffic information of every interfaces of these routers. I donot have mib file of zte and huawei. So, i want a generic mib file which can monitor every interfaces of these routers

3 Answers 3

11

As Nick R already mentioned, you need IF-MIB... details matter though.

You can correlate all OIDs to an interface name below by snmp walking ifName: 1.3.6.1.2.1.31.1.1.1.1.

High Speed interfaces

For high-speed interfaces (100Mbps or above) you should use 64-bit counters if the device supports them:

  • ifHCInOctets: 1.3.6.1.2.1.31.1.1.1.6 (64-bit Octets in counter)
  • ifHCOutOctets: 1.3.6.1.2.1.31.1.1.1.10 (64-bit Octets out counter)
  • ifHCInUcastPkts: 1.3.6.1.2.1.31.1.1.1.7 (64-bit Packets in counter)
  • ifHCOutUcastPkts: 1.3.6.1.2.1.31.1.1.1.11 (64-bit Packets out counter)
  • ifHighSpeed: 1.3.6.1.2.1.31.1.1.1.15 (An estimate of the interface's current bandwidth in units of 1Mbps)

Low Speed interfaces

Lower speed interfaces can get by with 32-bit counters. If you use 32-bit counters on high-speed interfaces, they can wrap quickly; a 10 Mbps stream of back-to-back, full-size packets causes ifInOctets to wrap in just over 57 minutes. At 100 Mbps, the minimum wrap time is 5.7 minutes, and at 1 Gbps, the minimum is 34 seconds Note 1

  • ifInOctets: 1.3.6.1.2.1.2.2.1.10 (32-bit Octets in counter)
  • ifOutOctets: 1.3.6.1.2.1.2.2.1.16 (32-bit Octets out counter)
  • ifInUcastPkts: 1.3.6.1.2.1.2.2.1.11 (32-bit Packets in counter)
  • ifOutUcastPkts: 1.3.6.1.2.1.2.2.1.17 (32-bit Packets out counter)
  • ifSpeed: 1.3.6.1.2.1.2.2.1.5 (Currently negotiated speed of the interface - Max: 4.294 Gbps)

Note 1: Quoted from Cisco's SNMP FAQ

1
  • The link refers to the original IF-MIB, without the ifXTable extensions. The full description can be found at rfc2863. Cisco has a plain text version of the extended IF-MIB. Aug 5, 2012 at 21:30
3

IF-MIB should be what you are looking for. The OID you want is ifInOctets and ifOutOctets.

3

Cacti is the most strait forward way to go.

Download an install it, it will work with a lot of routers and switches straight out of the box. Also, Observium is even easier to get going but less customisable than Cacti; although it does also work with most switches and routers strait out of the box.

Update: Forgot to say these include the MIBs!

1
  • +1 for observium, it's great if you're a service provider Jun 28, 2012 at 21:03

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .