Take the 2-minute tour ×
Server Fault is a question and answer site for professional system and network administrators. It's 100% free, no registration required.

Im trying to configure SAP HADR with the primary and standby server. Configurations seems to be ok but the database of standby server deactivates automatically. When i run the command db2 activate database in the standby server it will successfully activated but after a few seconds database gets deactivated again. And with this scenario, nearsync of logs is not consistent. Please advice what would be the possible cause of deactivation of database.

SAP ECC6.0 DB6 9.1

share|improve this question
add comment

1 Answer

You don't activate the database on the standby DB. The standby DB is always is rollforward mode. You can check this by typing db2top and them u.

Regards

share|improve this answer
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.