Take the 2-minute tour ×
Server Fault is a question and answer site for professional system and network administrators. It's 100% free, no registration required.

I was wondering if it was possible to make the polycomm devices automatically dial out without the use of the "Dial" button. We have user's who are mistaking this for the phone being broken when they try to dial out and if it was setup as dial when 10 digits are entered into the phone. Is it possible to have that configuration in the sip.cfg file in an Asterisk based system?

Thanks to anybody who responds!!

share|improve this question

closed as off topic by John Gardeniers, Frands Hansen, Scott Pack, Magellan, Sven Nov 9 '12 at 10:48

Questions on Server Fault are expected to relate to professional server, networking, or related infrastructure administration within the scope defined by the community. Consider editing the question or leaving comments for improvement if you believe the question can be reworded to fit within the scope. Read more about reopening questions here.If this question can be reworded to fit the rules in the help center, please edit the question.

1  
If a phone requires you to press a key to dial the number (just like mobile phones do) then there is nothing you can configure on another system to change that. As for the problem, I'd hate to see your users try to use more complex technology, such as a toaster. –  John Gardeniers Aug 24 '12 at 23:14
    
Knowing the phone model might help answer your question... –  voretaq7 Aug 25 '12 at 3:57

1 Answer 1

Not sure I got the right section from my sip.cfg, but I don't need to press the dial button:

<dialplan dialplan.impossibleMatchHandling="0" dialplan.removeEndOfDial="1"
 dialplan.applyToUserSend="1" dialplan.applyToUserDial="1"
 dialplan.applyToCallListDial="0" dialplan.applyToDirectoryDial="0">
 <digitmap dialplan.digitmap="[2-9]11|0T|011xxx.T|[0-1][2-9]xxxxxxxxx|[2-9]xxxxxxxxx|
     [2-9]xxxT|[2-9]xxxxxxT|*xx.T|1xT" 
     dialplan.digitmap.timeOut="3|3|3|3|3|3|3|3|3"/>
     <routing>
         <server dialplan.routing.server.1.address=""
         dialplan.routing.server.1.port="5060"/>
             <emergency dialplan.routing.emergency.1.value="911"
             dialplan.routing.emergency.1.server.1="1"/>
     </routing>
 </dialplan>
share|improve this answer

Not the answer you're looking for? Browse other questions tagged or ask your own question.