I have an old SSG-140 that I wanted to use as an NTP server for a number of devices - is this device able to act as a stable NTP time source?
My Linux clients can't seem to stay synced to the device - they keep resetting their clocks:
Dec 6 10:13:45 host1 ntpd: synchronized to 10.100.100.1, stratum 1 Dec 6 10:14:46 host1 ntpd: time reset -2.000141 s
I know the Juniper is able to see the NTP servers because it set its clock correctly, and when I query it, it claims to be an NTP server:
netops@appprd2m1:~$ ntpdate -q 10.100.100.1 server 10.100.100.1, stratum 1, offset -0.683934, delay 1.02910 6 Dec 10:33:25 ntpdate: step time server 10.100.100.1 offset -0.683934 sec
The lowest stratum clock it's syncing to is stratum 2, so I don't know why the Juniper is claiming to be stratum 1 -- it should be reporting itself as a stratum 3 source.
Here's the Juniper config:
NTP is Enabled Primary server: 184.108.40.206 (src i/f: ethernet0/7) Backup1 server: 220.127.116.11 (src i/f: ethernet0/7) Backup2 server: 18.104.22.168 (src i/f: ethernet0/7) Authentication Mode: None Max Allowed Adjustment: 300 second(s) Request Interval: 5 minute(s). Sync NTP time to peer: Disabled Update Status: Idle Last Update at: 12/06/2012 10:40:14
I suspect that the Juniper isn't slewing its clock to sync with its NTP peer, but is stepping its own clock every 5 minutes when it queries the remote NTP server, which is why the Linux clients can't stay synced.
My Linux clients don't have direct access to the internet, so I can't just tell them to use a public NTP server (though if I have to, I can set up a DMZ linux server to act as an NTP server, I was trying to avoid that by using the Juniper). This Juniper device is 4 or 5 years old, so I wouldn't be surprised if it has some hardware problem that's giving it unusual clock skew.
I don't think all 8 of my Linux servers themselves have a local clock skew problem, as I have a half dozen identical servers (all purchased at the same time) in a different coloc that are successfully able to sync with public NTP servers.
Has anyone else successfully used a Juniper SSG device as an NTP server?